Featured
Keyboard emulation using GPIO pins and arcade buttons on Raspberry Pi
Read more →
Tough DIY electronic project frames by resin infusing 3D prints
Tough DIY electronic project frames by resin infusing 3D prints
Read more →
Adding rigidity and aesthetics to the simple arcade frame
Read more →
Adding a rear panel to the simple arcade stick build
Adding a rear panel to the simple arcade stick build
Read more →
Simple and fast 3D printed and wood arcade stick build
Simple and fast 3D printed and wood arcade stick build
Read more →
Tie Fighter Conversion (H107C)
Tie Fighter Conversion (H107C)
Read more →
Tie Fighter Conversion (H107L)
Tie Fighter Conversion (H107L)
Read more →
Building a heater vent rover to investigate source of strange smell
Read more →
3D Printing Virtual Reality Lenses for Smartphones
3D Printing Virtual Reality Lenses for Smartphones
Read more →
Preventing failed prints with filament feed encoder and Arduino
Preventing failed prints with filament feed encoder and Arduino
Read more →
The iCade to arcade stick mod
Read more →
Connecting Arcade Buttons to Raspberry Pi GPIO Pins
Connecting Arcade Buttons to Raspberry Pi GPIO Pins
Read more →
Measuring home water consumption with Raspberry Pi
Read more →
3D print arcade fight stick controller
3D print arcade fight stick controller
Read more →
Arduino arcade joystick controller
Read more →
IMG_1140.JPG
3D Printing molds for custom joystick balltop spheres
Read more →
Nexus 7 Car Install - ROM and Software Information
Nexus 7 Car Install - ROM and Software Information
Read more →
Optimizing 3D prints and getting the most out of your 3D printer
Optimizing 3D prints and getting the most out of your 3D printer
Read more →
Building an arcade stick case fast
Read more →
Removing the learning curve from game development
Read more →
IMG_7039.JPG
Vector path crosshatching (in Illustrator) to speed up laser cutting
Read more →
The first attempts tried to grip the binder clips but this proved to be unstable and require too much force. Longer and stronger lever arms didn't change the instability of the binder clip. The far right design was an attempt to 3D print a "clothesp
Steps towards home manufacturing with robotics and 3D printing
Read more →
These were the designs I had posted on forums requesting feedback
Raspberry Pi Arcade Controller
Read more →
IMG_1096.jpg
Projection map a 3D printed face
Read more →
Transient
Read more →
IMG_4641.jpg
HoldMyiPhone Product Development: Lessons and Tips
Read more →